Hypertherm Powermax105 SYNC Plasma Cutter, 50 ft 75° Hand Torch, 3-Phase, 059626

The Hypertherm Powermax105 SYNC plasma cutter with 50 ft hand torch is a professional air plasma system for cutting and gouging up to 1-1/4 in. (32 mm) on 200-600 V, 3-phase power. This hand-cutting package includes a 75° SmartSYNC torch on a 50 ft lead and a 50 ft work clamp, and it has no CPC port for automated hookup.

RFID-enabled SmartSYNC torches set up the process automatically, and the single-piece cartridge consumable tracks its own usage data. End-of-life detection on both the torch and the power source shows when to change a cartridge, and a used-up cartridge stays flagged as spent, so it cannot be reused by mistake; detection is disabled with a Fine Cut hand cutting cartridge, below 40 A on any cartridge, or below 55 A when the cartridge is not communicating. Travel speed is 20 ipm on 1-1/4 in. metal, with air recommended at 85 psi (5.9 bar) and 460 scfh (7.7 scfm).

Each SmartSYNC torch has an internal cap sensor that confirms the cartridge is seated, a reader that relays the RFID chip data to the power source, ready-state LEDs on the handle and a 7-step amperage LED for choosing one of seven presets. A torch lock switch permits consumable changes while the power supply stays on. The box holds the power source, the 50 ft torch and work clamp, two 105 A and one 85 A drag cartridges and the operator and safety manuals. The power source weighs 88 lbs and measures 23.3 x 10.8 x 20 in. (L x W x H).

Highlights

• Cuts and gouges up to 1-1/4 in. (32 mm); 20 ipm travel speed on 1-1/4 in. metal

• 200-600 V, 3-phase only, 50-60 Hz input

• 75° SmartSYNC hand torch with a 50 ft lead and a 50 ft work clamp

• Hand-torch package without a CPC port

• Power source weighs 88 lbs; 23.3 x 10.8 x 20 in. (L x W x H)

• SmartSYNC torch reads the cartridge by RFID to automate set-up; life data is tracked

Specifications

What's in the box

• Powermax105 SYNC power source

• 75° SmartSYNC torch with 50 ft lead

• 50 ft work clamp

• Two 105 A drag cartridges and one 85 A drag cartridge

• Operator and safety manuals

Good to know

• Check the input power (voltage, phase and amperage) against your supply before you order.