Hypertherm Powermax105 SYNC Plasma Cutter, 25 ft 75° and 15° Hand Torch, 3-Phase
The Hypertherm Powermax105 SYNC plasma cutter with 25 ft 75° and 15° hand torch is a professional air plasma system for cutting and gouging up to 1-1/4 in. (32 mm) on 200-600 V, 3-phase power. The package adds drag cutting and max removal gouging cartridges, a 25 ft work clamp and a CPC port on the power source.
RFID-enabled SmartSYNC torches set up the process automatically, and the single-piece cartridge consumable tracks its own usage data. End-of-life detection on both the torch and the power source shows when to change a cartridge, and a used-up cartridge stays flagged as spent, so it cannot be reused by mistake; detection is disabled with a Fine Cut hand cutting cartridge, below 40 A on any cartridge, or below 55 A when the cartridge is not communicating. Travel speed is 20 ipm on 1-1/4 in. metal, with air recommended at 85 psi (5.9 bar) and 460 scfh (7.7 scfm).
Each SmartSYNC torch has an internal cap sensor that confirms the cartridge is seated, a reader that relays the RFID chip data to the power source, ready-state LEDs on the handle and a 7-step amperage LED for choosing one of seven presets. A torch lock switch permits consumable changes while the power supply stays on. The box holds the power source, the 25 ft 75° and 15° SmartSYNC torch and work clamp, three 105 A drag and two 105 A max removal gouging cartridges and the manuals. The power source weighs 88 lbs and measures 23.3 x 10.8 x 20 in. (L x W x H).
Highlights
Cuts and gouges up to 1-1/4 in. (32 mm); 20 ipm travel speed on 1-1/4 in. metal
200-600 V, 3-phase only, 50-60 Hz input
25 ft 75° and 15° SmartSYNC hand torch with a 25 ft work clamp
Drag and max removal gouging cartridges included; CPC port
Power source weighs 88 lbs; 23.3 x 10.8 x 20 in. (L x W x H)
SmartSYNC torch reads the cartridge by RFID to automate set-up; life data is tracked
Specifications
Brand | Hypertherm |
Manufacturer part number | 059634 |
Input power | 200-600 V, 3-phase only, 50-60 Hz |
Cut and gouge capacity | Up to 1-1/4 in. (32 mm) |
Travel speed | 20 ipm on 1-1/4 in. metal |
Recommended air supply | 85 psi (5.9 bar), 460 scfh (7.7 scfm) |
Power source weight | 88 lbs |
Dimensions (L x W x H) | 23.3 x 10.8 x 20 in. |
Torch | 75° and 15° SmartSYNC hand torch, 25 ft |
Work clamp | 25 ft |
Automation interface | CPC port |
Cartridges included | Three 105 A drag, two 105 A max removal gouging |
What's in the box
Powermax105 SYNC power source
25 ft 75° and 15° SmartSYNC hand torch
25 ft work clamp
Three 105 A drag cartridges and two 105 A max removal gouging cartridges
Operator and safety manuals
Good to know
Check the input power (voltage, phase and amperage) against your supply before you order.