Hypertherm Powermax105 SYNC Plasma Cutter, 50 ft 180° Machine Torch, CPC, 059638
The Hypertherm Powermax105 SYNC plasma cutter with 50 ft 180° machine torch is a professional air plasma system that cuts and gouges up to 1-1/4 in. (32 mm) on 200-600 V, 3-phase power, set up here for mechanized cutting. The power source has a CPC port, and the package adds a 50 ft work clamp and mechanized cartridges.
RFID-enabled SmartSYNC torches set up the process automatically, and the single-piece cartridge consumable tracks its own usage data. End-of-life detection on both the torch and the power source shows when to change a cartridge, and a used-up cartridge stays flagged as spent, so it cannot be reused by mistake; detection is disabled with a Fine Cut hand cutting cartridge, below 40 A on any cartridge, or below 55 A when the cartridge is not communicating. Travel speed is 20 ipm on 1-1/4 in. metal, with air recommended at 85 psi (5.9 bar) and 460 scfh (7.7 scfm).
Each SmartSYNC torch has an internal cap sensor that confirms the cartridge is seated, a reader that relays the RFID chip data to the power source, ready-state LEDs on the handle and a 7-step amperage LED for choosing one of seven presets. A torch lock switch permits consumable changes while the power supply stays on. The box holds the power source with CPC port, the 50 ft 180° SmartSYNC machine torch and work clamp, two 105 A and one 85 A mechanized cartridges and the operator and safety manuals. The power source weighs 88 lbs and measures 23.3 x 10.8 x 20 in. (L x W x H).
Highlights
Cuts and gouges up to 1-1/4 in. (32 mm); 20 ipm travel speed on 1-1/4 in. metal
200-600 V, 3-phase only, 50-60 Hz input
50 ft 180° SmartSYNC machine torch with a 50 ft work clamp
CPC port on the power source
Power source weighs 88 lbs; 23.3 x 10.8 x 20 in. (L x W x H)
SmartSYNC torch reads the cartridge by RFID to automate set-up; life data is tracked
Specifications
Brand | Hypertherm |
Manufacturer part number | 059638 |
Input power | 200-600 V, 3-phase only, 50-60 Hz |
Cut and gouge capacity | Up to 1-1/4 in. (32 mm) |
Travel speed | 20 ipm on 1-1/4 in. metal |
Recommended air supply | 85 psi (5.9 bar), 460 scfh (7.7 scfm) |
Power source weight | 88 lbs |
Dimensions (L x W x H) | 23.3 x 10.8 x 20 in. |
Torch | 180° SmartSYNC machine torch, 50 ft |
Work clamp | 50 ft |
Automation interface | CPC port |
Cartridges included | Two 105 A mechanized, one 85 A mechanized |
What's in the box
Powermax105 SYNC power source with CPC port
50 ft 180° SmartSYNC machine torch
50 ft work clamp
Two 105 A mechanized cartridges and one 85 A mechanized cartridge
Operator and safety manuals
Good to know
Check the input power (voltage, phase and amperage) against your supply before you order.