Lincoln Electric LN-25X Wire Feeder One-Pak with Magnum PRO Curve 300 MIG Gun

The Lincoln Electric LN-25X Wire Feeder One-Pak pairs the portable, lightweight LN-25X field construction feeder with a Magnum PRO Curve 300 MIG gun and a drive roll kit for 0.040-0.045 in. cored wire. CrossLinc gives voltage control at the feeder with no control cables on a CrossLinc-compatible power source, and TVT holds the voltage set at the feeder over long weld cables.

Magnum PRO Curve guns are built for MIG or flux-cored welding with a classic curved handle, and they pair Copper Plus contact tips with Magnum PRO expendables for fewer tip and expendable changes over long hours of fabrication welding. The cored wire rolls supplied in this One-Pak are .045 knurled drive rolls.

On the feeder side, a heavy-duty cast aluminum Maxtrac wire drive handles the feeding, the electronics are fully encapsulated and environmentally protected, and the flame-resistant case can be replaced in under five minutes. Dropping control cables means less jobsite clutter, quicker setup and fewer trips back to the power source when settings change.

Highlights

• One-Pak: LN-25X wire feeder with Magnum PRO Curve 300 welding gun

• Cored-wire drive roll kit for 0.040-0.045 in. wire; .045 knurled rolls

• CrossLinc voltage control from the feeder; no extra cables

• TVT corrects for voltage lost in long weld cables

• Curved-handle gun with Copper Plus contact tips and Magnum PRO expendables

• Heavy-duty cast aluminum Maxtrac wire drive

Specifications

What's in the box

• LN-25X wire feeder

• Magnum PRO Curve 300 welding gun

• Cored wire drive roll kit, 0.040-0.045 in. (.045 knurled rolls)