top of page
Lincoln Electric Power MIG 215 MPi Multiprocess Welder with Aluminum One-Pak
Lincoln Electric Power MIG 215 MPi Multiprocess Welder with Aluminum One-Pak
Lincoln Electric Power MIG 215 MPi Multiprocess Welder with Aluminum One-Pak
Lincoln Electric Power MIG 215 MPi Multiprocess Welder with Aluminum One-Pak
Lincoln Electric Power MIG 215 MPi Multiprocess Welder with Aluminum One-Pak
SKU: K4877-1

Lincoln Electric Power MIG 215 MPi Multiprocess Welder with Aluminum One-Pak

$2,669.00Price
Quantity

This Aluminum One-Pak from Lincoln Electric builds on the Power MIG 215 MPi dual-voltage multiprocess welder, which runs on 120 V or 230 V and covers MIG, flux-cored, stick and DC TIG, and adds included accessories with an emphasis on aluminum MIG welding. It targets general fabrication, small contractor operations and repair.

The power source reaches 220 A on 230 V and 140 A on 120 V, with MIG rated at 215 A, 24.8 V and 30% on 230 V. Its Ready.Set.Weld system recommends wire feed speed and voltage from the material type and thickness, and the ArcFX display shows the recommendations.

TIG readiness is built in through a TIG solenoid and a foot pedal adapter. The case has lift points that make the unit easier to move around the shop, the wire drive feeds consistently across wire types and diameters, and the aluminum-specific accessories in this One-Pak support aluminum MIG welding from the start.

Highlights

  • Aluminum One-Pak built on the Power MIG 215 MPi dual-voltage welder

  • Dual input voltage: 120 V and 230 V, single-phase, 60 Hz

  • Output range up to 220 A on 230 V and up to 140 A on 120 V

  • Included aluminum-specific accessories for aluminum MIG welding

  • TIG-ready: solenoid and foot pedal adapter are built into the unit

  • Ready.Set.Weld setup and ArcFX display

Specifications

Brand

Lincoln Electric

Manufacturer part number

K4877-1

Processes

MIG (GMAW), flux-cored (FCAW-S, FCAW-G), stick (SMAW), DC TIG (GTAW)

Input voltage

120 V or 230 V, single-phase, 60 Hz (switch-selectable)

Output range

20-140 A DC (120 V); 20-220 A DC (230 V)

Rated output, MIG

105 A / 19.3 V / 40% (120 V); 215 A / 24.8 V / 30% (230 V)

Rated output, stick

85 A / 23.4 V / 40% (120 V); 175 A / 27 V / 30% and 110 A / 24.4 V / 100% (230 V)

Rated output, TIG

130 A / 15.2 V / 40% (120 V); 175 A / 17 V / 30% and 110 A / 14.4 V / 100% (230 V)

Max open circuit voltage

56 V

Polarity

DC (DCEP / DCEN selectable)

Wire feed speed

50-500 ipm (1.3-12.7 m/min)

Wire diameter

0.025-0.045 in. (0.6-1.1 mm)

IEC rating

IP21S

TIG readiness

Built-in TIG solenoid and foot pedal adapter

Good to know

  • Check the input power (voltage, phase and amperage) against your supply before you order.

    bottom of page