Miller 20 Series Digital Wire Feeder, 15 ft Bernard BTB 300A MIG Gun, 951780001

The Miller 20 Series Digital is a wire feeder for MIG (GMAW) and flux-cored welding with run-in control, remote voltage control and digital meters included. This package adds a 15 ft Bernard BTB 300 A MIG gun and a 10 ft 14-pin interconnecting cord, and the feeder handles .023 to 5/64 in. wire at 75-750 IPM.

On top of those meters and voltage controls, trigger hold lets the operator make long welds without holding the gun trigger, and on-board motor ramp and burnback control give positive arc starts and clean stops on a variety of power sources. The 16-gauge sheet metal housing stands up to rough service, and with the optional wire reel assembly (108008) the feeder takes a 60 lb coil.

Input power is 24 VAC, 3.5 A, 50/60 Hz; the feeder weighs 46 lbs and measures 16 in. high, 12.375 in. wide and 27.875 in. deep. Besides the gun and the cord, the package includes four .035/.045 V-groove drive rolls and Centerfire contact tips, three in .035 and two in .045.

Highlights

• Run-in control, remote voltage control and digital meters included

• Feeds MIG and flux-cored wire at 75-750 IPM

• Includes a 15 ft Bernard BTB 300 A MIG gun and 10 ft 14-pin interconnecting cord

• Trigger hold, burnback control and motor ramp control built in

• Wire capacity .023-5/64 in.; 60 lb coils with optional wire reel assembly (108008)

• 46 lbs; 16-gauge sheet metal housing

Specifications

What's in the box

• 20 Series Digital Feeder

• 15-foot Bernard BTB MIG gun, 300 A

• 10-foot 14-pin interconnecting cord

• .035/.045 V-groove drive rolls (4 rolls)

• Centerfire contact tips: 3 in .035 and 2 in .045