Miller ArcReach SuitCase 8 Wire Feeder with Bernard BTB 300A MIG Gun, 951726001

This Miller ArcReach SuitCase 8 package pairs the suitcase wire feeder with a Bernard BTB 300 A MIG gun. ArcReach puts weld adjustments at the feeder or a remote instead of at a distant power source, Cable Length Compensation keeps the set voltage accurate over long cable runs, and SunVision digital meters read clearly from almost any angle, even in direct sunlight.

Adjustments happen at the feeder or a remote, so nobody has to trace the weld cable back to a power source that may be hundreds of feet away, and Cable Length Compensation (CLC) automatically corrects voltage for cable length so the voltage set is the voltage delivered. A heavy-duty drive motor with tachometer control keeps wire feed speed accurate within and between welds, the front panel carries trigger hold, wire jog and gas purge, and a wide voltage range suits small and large wires.

The impact-resistant, flame-retardant case keeps moisture, dust and other contaminants away from the components and wire; built-in slide rails let it be dragged into position, and the door allows wire changes with the feeder upright or on its side. The potted and trayed main circuit board has full trigger isolation that keeps a shorted gun trigger from affecting feeder operation, and a gun locking tab, recessed gas inlet and double-filtered gas valve protect the gun connection and gas supply. Ultra-low drag inlet guide pins and a scaled wire pressure knob make wire loading easy and keep drive roll pressure consistent.

Highlights

• Bernard BTB 300 A gun package with the ArcReach SuitCase 8 feeder

• Settings adjusted at the feeder or a remote; CLC compensates for weld cable length

• SunVision digital meters, readable in direct sunlight

• Trigger hold, wire jog and gas purge on the front panel

• Potted and trayed circuit board with full trigger isolation

• Gun locking tab, recessed gas inlet and double-filtered gas valve

Specifications