Miller Deltaweld 350 MIG Welder Power Source, ArcConnect, 230/460V 3-Phase

The Miller Deltaweld 350 is a three-phase MIG welder power source with ArcConnect and Accu-Pulse technology, delivering 20-400 A at 10-38 V from 230/460 V input. This version has no digital meters or 14-pin receptacle: it is meant to run with an Intellx or Intellx Pro wire feeder, which carries the meters and point-of-use controls.

Accu-Pulse gives precise control of the pulse arc and the molten puddle, and in many applications it can raise wire feed speed and deposition by 20 to 25 percent. ArcConnect's high-speed signals improve weld performance and allow the point-of-use controls to sit at the feeder. EZ-Set parameters, Wind Tunnel Technology and Fan-On-Demand are standard on this MIG (GMAW) power source.

An Intellx feeder adds jog/purge controls, arc control, remote voltage and digital meters, while the Intellx Pro also runs stainless, flux-cored and metal-cored wire plus other wire and gas types. Intellx drive systems use balanced-pressure drive rolls that feed the wire straight, and the accu-mate connection keeps the gun aligned in the drive-roll carrier. The power source weighs 115 lbs and measures 22.36 in. H x 12.38 in. W x 27.88 in. L.

Highlights

• 20-400 A output range at 10-38 V

• 230/460 V input, three-phase only

• ArcConnect and Accu-Pulse technology with EZ-Set parameters

• No digital meters or 14-pin receptacle on this version

• Wind Tunnel Technology and Fan-On-Demand

• 115 lbs; 22.36 in. H x 12.38 in. W x 27.88 in. L

Specifications

What's in the box

• Deltaweld 350 power source

Good to know

• Check the input power (voltage, phase and amperage) against your supply before you order.